1991 Explor 4WD V6-245 40L Maint Align Sys Info Tech Serv Bull Other Serv Bull Pg 873
PROCEDURE 6 - 2005
42
PROCEDURE 7 - FRONT
W6
ROAD TEST - FRONT
W6
OASIS CODES: 301000, 303000
Service Procedure
1.
Check and adjust brake pad clearances and caliper knuckle clearances as follows:
a.
Remove the pins from the caliper.
b.
While holding the caliper in place against the bottom pin rails, Figure 1, measure the clearance between the caliper and the top pin rails.
Clearance should be a minimum of 0.3B mm (0.015").
c.
If the clearance is insufficient, replace the caliper and measure again. If clearance concern still exists, replace the knuckle.
NOTE:
CHECK THE CLEARANCE ON THE NEW KNUCKLE BEFORE INSTALLATION.
d.
After measuring the caliper/knuckle for proper clearances, remove both calipers and inner pad assemblies.
e.
Remove the anti-rattle clip from the inner pad.
