Explorer 4WD V6-245 4.0L (1991)
Adjust the position as follows:
a.
Pull off the wiper arm and carefully move it one tooth at a time.
b.
Install and check measurement after each movement, Figure 1.
c.
Set wiper arm in the arm stop after final adjustment.
5.
Wait for 15 minutes to ensure that the thermoprotector is reset.
6.
Turn ON the rear wiper switch and check operation of the rear wiper. If the rear wiper does not turn on and the arm stop position is properly
adjusted, perform normal diagnostics.
7.
Turn OFF the rear wiper switch and the ignition.
OTHER APPLICABLE ARTICLES:
NONE
WARRANTY STATUS:
Eligible Under Basic Warranty Coverage For 1991 Models And Bumper To Bumper Warranty Coverage For All Other Models
OPERATION DESCRIPTION
TIME
922412A
Inspect And Adjust
0.3 Hr.
DEALER CODING
BASIC PART NO.
CONDITION CODE
17508
42
OASIS CODES:
202000
