Explorer 4WD V6-245 4.0L SOHC VIN K SFI (2001)
3. CAUTION: The torsion bar adjustment bolt is coated with: dry adhesive; and must be replaced if it is backed off or removed. Failure to do so can
cause the adjustment bolt to loosen during operation and cause a loss of vehicle alignment.
Preload the torsion bar.
1
Install the Torsion Bar Tool and the adapters.
2
Tighten the Torsion Bar Tool until the new adjustment bolt and nut can be installed.
3
Turn the adjustment bolt until the preliminary adjustment measurement (recorded length of the old adjustment bolt) is reached.
4. Install the torsion bar cover plate.
1
Position the torsion bar cover plate.
2
Install the torsion bar cover plate bolts.
5. Note: If equipped with air suspension, reactivate the system by turning on the air suspension switch.
Lower the vehicle.
6. Adjust the ride height.
7. Check the alignment.