Explorer 4WD V6-245 4.0L SOHC VIN K SFI (2001)
11. Note: Remove any excess grease from the inboard halfshaft boot mating surface before positioning into place.
Position the inboard halfshaft boot and boot clamp.
1. Position the inboard halfshaft boot into place.
2. Position the boot clamp.
12. Insert a dulled screwdriver blade to relieve built-up air pressure in the halfshaft boot.
13. Use the CV Boot Clamp Installer to install the inboard boot clamps.
14. Install the front wheel halfshaft.
Removal and Installation