Explorer 4WD V6-245 4.0L VIN X SFI (1997)
Differential Case: Service and Repair
Rear - 8.8 Inch Ring Gear
Removal and Installation
REMOVAL
1. Remove the axle shafts.
2. Wipe the lubricant from the internal working parts and visually inspect for wear or damage.
3. Rotate the differential case to see if there is any roughness which would indicate damaged bearings or gears.
4. Position Dial Indicator With Bracketry and inspect ring gear backface runout.
NOTE:
-
Specifications shown are maximum runout.
-
There is a space between the anti-lock speed sensor ring and the ring gear for measuring ring gear backface runout.
5. Remove Dial Indicator With Bracketry.
6. Mark the differential bearing caps for correct alignment during installation.
