Explorer 4WD V6-4.0L (2009)
-
To install, tighten to 121 Nm (89 lb-ft).
4. Remove the safety belt guide cover in the following sequence.
1. Pull out at the bottom and release the 2 safety belt guide cover retainers.
2. Tip the bottom of the safety belt guide cover up to release the top retainer and remove the safety belt guide cover.
Sport Trac vehicles
5. Remove the retainers and the upper latch cover.
All vehicles
6. Release the backrest trim cover J-clip.
7. Remove all the staples in the backrest support panel.
8. Reposition the backrest trim cover and foam pad to access the latch cover screws.
9. Remove the latch covers in the following sequence.
1. Remove the 4 latch cover screws.
2. Detach the backrest trim cover from the latch covers.
3. Remove the latch covers.
10. NOTICE: Use care when separating the backrest trim cover from the hook-and-loop strip, or the hook-and-loop strip can be torn from
the backrest foam pad.
Separate the hook-and-loop fasteners and invert the backrest trim cover.
11. NOTE: The inboard and outboard head restraint sleeves are not interchangeable.
NOTE: The head restraint sleeves incorporate an alignment tab that must face forward when installed.
Squeeze together the tip of the head restraint sleeve and pull the sleeve out of the frame tube.
12. Remove the backrest trim cover.
-
Feed the safety belt out through the opening in the backrest trim cover.
13. To install, reverse the removal procedure.
Seat Backrest Cover - Second Row, 60 Percent, E-Z Entry
Seat Backrest Cover - Second Row, 60 Percent, E-Z Entry
