Explorer 4WD V6-4.0L (2009)
2. Release the cable from the seat riser and remove the cushion trim cover.
3. To install, reverse the removal procedure.
Seat Cushion Cover - Second Row, 40 Percent E-Z Entry
Seat Cushion Cover - Second Row, 40 Percent E-Z Entry
Removal and Installation
1. Remove the 2 screws and the latch feet release bar.
2. Release all the cushion trim cover retainers and pin-type retainers.
3. NOTICE: Use care when separating the cushion trim cover from the hook-and-loop strip, or the hook-and-loop strip can be torn from the
cushion foam pad.
Release the hook-and-loop strips and remove the cushion trim cover from the cushion foam pad.
4. To install, reverse the removal procedure.
-
Make sure the lower anchor and tethers for children wires at the rear of the cushion frame are positioned through the cushion trim cover and
accessible for use after installation.
Seat Cushion Cover - Second Row, 40 Percent, Bench
Seat Cushion Cover - Second Row, 40 Percent, Bench
Removal and Installation
1. Remove the second row 40 percent seat of the 60/40 bench seat. For additional information, refer to Seat - Second Row, Sport Trac or Seat -
Second Row, Explorer, 60/40 Bench See: Service and Repair/Second Row Seating/Seat - Second Row, 60/40 Bench.
2. NOTICE: Use care when separating the cushion trim cover from the hook-and-loop strip, or the hook-and-loop strip can be torn from the
cushion foam pad.
Release the J-clips, separate the hook-and-loop fasteners, remove the hog rings and the cushion trim cover.
3. To install, reverse the removal procedure.
Seat Cushion Cover - Second Row, 60 Percent, Bench
Seat Cushion Cover - Second Row, 60 Percent, Bench
Removal and Installation
1. Remove the second row 60 percent seat of the 60/40 bench seat. For additional information, refer to Seat - Second Row, Sport Trac or Seat -
Second Row, Explorer, 60/40 Bench See: Service and Repair/Second Row Seating/Seat - Second Row, 60/40 Bench.
2. NOTICE: Use care when separating the cushion trim cover from the hook-and-loop strip, or the hook-and-loop strip can be torn from the
cushion foam pad.
Release the J-clips, separate the hook-and-loop fasteners, remove the hog rings and the cushion trim cover.
3. To install, reverse the removal procedure.
