Explorer 4WD V6-4.0L (2009)
Disassembly and Assembly
1. Remove the second row 60 percent seat of the 60/40 bench seat. For additional information, refer to Seat - Second Row, Sport Trac or Seat -
Second Row, Explorer, 60/40 Bench See: Service and Repair/Second Row Seating/Seat - Second Row, 60/40 Bench.
2. Remove the second row 60 percent bench seat backrest. For additional information, refer to Seat Backrest - Second Row, 60 Percent, Bench See:
Seat Back/Service and Repair/Removal and Replacement/Second Row Seating/Seat Backrest/Seat Backrest - Second Row, 60 Percent, Bench.
3. Remove the inboard upper pivot latch bolt.
-
To install, tighten to 40 Nm (30 lb-ft).
4. NOTICE: Use care when separating the cushion trim cover from the hook-and-loop strip, or the hook-and-loop strip can be torn from the
cushion foam pad.
Release the J-clips, separate the hook-and-loop fasteners, remove the hog rings and the cushion trim cover.
5. Remove the cushion foam pad.
6. Remove 2 cushion pad supports.
7. To assemble, reverse the disassembly procedure.
Seat Cushion - Second Row, Bucket
Seat Cushion - Second Row, Bucket