Explorer 4WD V6-4.0L (2009)
-
Tighten to 40 Nm (30 lb-ft).
3. NOTE: RH shown, LH similar.
Tighten the 4 new exhaust Y-pipe dual catalytic converter-to-exhaust manifold nuts.
-
Tighten to 40 Nm (30 lb-ft).
4. Install the transmission support crossmember.
5. Connect the HO2S and CMS electrical connectors.
6. Check to see if the exhaust system isolators are at zero load. If the exhaust system isolators are not at zero load, then carry out the exhaust system
alignment procedure. For additional information, refer the Exhaust System Alignment See: Service and Repair/Exhaust System Alignment.
