Explorer 4WD V6-4.0L (2009)
Removal and Installation
All vehicles
1. Remove the suction accumulator. For additional information, refer to Suction Accumulator See: Accumulator HVAC/Service and Repair.
2. Remove the A/C line bracket nut at the dash panel and remove the A/C line bracket.
-
To install, tighten to 6 Nm (53 lb-in).
3. Remove the ground strap bolt at the dash panel.
4. Disconnect the evaporator outlet fitting.
-
Discard the O-ring seals.
Vehicles with 4.0L engine
5. Disconnect the Evaporative Emission (EVAP) return line fitting at the intake manifold.
