Explorer 4WD V6-4.0L (2009)
11. Connect the Fluid Transporter/Evacuator/Injector.
-
Connect the open end of the fluid hose from the Fluid Transporter/Evacuator/Injector to the Fluid Level and Fill Plug Adapter at the bottom of
the transmission fluid pan.
12. Apply a maximum of 206.85 kPa (30 psi) to the open end of the vacuum/pressure hose from the Rubber Tip Air Nozzle. Transmission fluid will
immediately start flowing out of the Fluid Transporter/Evacuator/Injector into the transmission fluid pan.
13. Add 0.5L (1 pt) of transmission fluid into the transmission fluid pan. Stop the process by releasing the air pressure and removing the Rubber Tip
Air Nozzle from the end of the hose.
14. Inspect the transmission fluid level in the Fluid Transporter/Evacuator/Injector. If the transmission fluid drains back into the canister, the
transmission is full. If no transmission fluid drains back, more transmission fluid will need to be added. Repeat Steps 12 and 13.
15. Once the transmission is full, place a Vacuum Pump Kit on the open end of the vacuum/pressure hose on the Fluid Transporter/Evacuator/Injector
and apply vacuum to the system. This will pull out any extra transmission fluid trapped in the system and direct it into the container.
16. Allow the transmission fluid to drain. Make sure that the TFT is between 27-49°C (80-120°F). When the transmission fluid comes out as a thin
stream or drip, the transmission fluid is at the correct level.
17. Reinstall the small (center) transmission fluid level indicating plug.
-
Tighten to 10 Nm (89 lb-in).
