Explorer 4WD V6-4.0L (2009)
![background image](/ford/explorer_4wd/v6-4.0l/Page-603001.png)
Malfunction Indicator Lamp: Description and Operation
Malfunction Indicator Lamp (MIL)
The MIL notifies the driver that the powertrain control module (PCM) has detected an on board diagnostic (OBD) emission-related component or system
concern. When this occurs, an OBD diagnostic trouble code (DTC) sets.
-
The MIL is located in the instrument cluster and is labeled CHECK ENGINE, SERVICE ENGINE SOON or the international standards
organization (ISO) standard engine symbol.
-
The MIL is illuminated during the instrument cluster prove out for approximately four seconds.
-
The MIL remains illuminated after instrument cluster prove out if:
-
an emission-related concern and DTC exists.
-
the PCM does not send a control message to the instrument cluster (applications with the MIL controlled through the communication link).
-
the PCM is operating in the hardware limited operation strategy (HLOS).
-
The MIL remains off during the instrument cluster prove out if an indicator or instrument cluster concern is present.
-
To turn off the MIL after a repair, a reset command from the scan tool must be sent, or three consecutive drive cycles must be completed without a
concern.
-
For all MIL concerns, go to Symptom Charts See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Symptom
Related Diagnostic Procedures/No Diagnostic Trouble Codes (DTCs) Present Symptom Chart Index.
-
If the MIL flashes at a steady rate, a severe misfire condition may exist.
-
If the MIL flashes erratically, the PCM can reset while cranking if the battery voltage is low.
-
The MIL flashes after a period of time with the ignition in the RUN position (engine not running) if DTC P1000 is set.
CHECK ENGINE, SERVICE ENGINE SOON, or ISO Standard Engine Symbol