Explorer 4WD V6-4.0L (2009)
Ignition Coil: Service and Repair
Ignition Coil
Ignition Coil
Removal and Installation
1. Disconnect the ignition coil electrical connector.
2. Disconnect the radio noise suppressor electrical connector.
3. NOTICE: It is important to twist the spark plug wire boot while pulling upward to avoid possible damage to the spark plug wire.
NOTE: Spark plug wires must be connected to the correct ignition coil terminal. For additional information, refer to the Cylinder-to-Coil
Terminal Relationship, Engine Ignition See: Description and Operation in the Description and Operation.
Squeeze the tabs and twist, while pulling upward to disconnect the 6 spark plug wires from the ignition coil.
4. Remove the 4 bolts and the ignition coil.
-
To install, tighten to 6 Nm (53 lb-in).
5. NOTE: Apply silicone dielectric compound to the inside of the ignition coil boots.
To install, reverse the removal procedure.
