Explorer 4WD V6-4.0L (2009)
USB Cable And Port-To-Accessory Protocol Interface Module (APIM)
Removal and Installation
1. Remove the 4 screws and the front floor console stowage door.
2. Remove the 2 screws and the front floor console rear trim panel.
-
Pull straight back to disengage the clips.
3. Remove the 2 screws and the front floor console finish panel.
-
Pull straight up to disengage the clips.
4. Using a suitable tool (such as a trim removal tool) pry the audio input jack bezel from the storage bin.
-
Disconnect the audio input jack electrical connector.
5. Disconnect the Universal Serial Bus (USB) port connector from the audio input jack bezel.
6. Remove the 4 screws and the front floor console stowage bin.