Explorer 4WD V6-4.0L (2009)
Power Steering Pump: Service and Repair
Power Steering Pump Pulley
Power Steering Pump Pulley - 4.0L
Removal and Installation
1. Disconnect the fan clutch electrical connector, remove the fan clutch wiring harness bracket bolt and position the harness aside.
-
To install, tighten to 7 Nm (62 lb-in).
2. Loosen the 3 power steering pump pulley bolts.
3. Rotate the tensioner and remove the engine accessory drive belt from the power steering pump pulley.
4. Remove the 3 bolts and the power steering pump pulley.
-
To install, tighten to 25 Nm (18 lb-ft).
5. To install, reverse the removal procedure.
