Explorer 4WD V6-4.0L (2009)
Removal
NOTICE: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure may result
in major service expense. New parts must be installed with the same part numbers or equivalent part, if replacement is necessary. Do not use a
replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct
retention of these parts.
1. Measure the distance from the center of the hub to the lip of the fender with the vehicle in a level, static ground position (curb height).
2. Remove the wheel and tire.
3. Using a suitable jack support the lower control arm near the lower ball joint.
4. Remove and discard the upper ball joint nut.
5. NOTICE: Do not use a hammer to separate the ball joint from the wheel knuckle or damage to the wheel knuckle can result.
NOTICE: Do not damage the ball joint boot while installing the C-Frame and Screw.
Using the C-Frame and Screw, separate the upper ball joint from the wheel knuckle.
6. Using a plastic tie strap, support the suspension at the wheel knuckle.
