Explorer 4WD V6-4.0L (2009)
2. Install 4 new O-rings on the transmission fluid cooler tube ends.
3. NOTE: Inspect the transmission case to make sure that the old O-rings are not stuck in the transmission case.
Position the transmission fluid cooler tubes into the transmission, then install the bolt for the transmission cooler tube retainer.
-
Tighten to 25 Nm (18 lb-ft).
4. Install the transmission fluid cooler tube bracket and install the transmission fluid cooler tube bracket nut.
-
Tighten to 12 Nm (106 lb-in).
5. NOTE: Install new U-joint strap bolts. If new U-joint strap bolts are not available, coat the threads of the original U-joint strap bolts with
threadlock and sealer.
If removed, install the U-joint straps and 4 new U-joint strap bolts.
-
Tighten to 19 Nm (168 lb-in).
6. Connect the engine oil low level sensor electrical connector and harness clips.
7. Connect the transmission fluid cooler tube to the radiator.
