Explorer 4WD V6-4.0L (2009)
-
To install, tighten the 6 new bolts to 30 Nm (22 lb-ft).
6. NOTE: If new flange bolts are not available and the originals are not damaged, they can be reused if the threads are coated with threadlock and
sealer.
Remove and discard the 4 driveshaft flange bolts.
-
To install, tighten the 4 new bolts to 112 Nm (83 lb-ft).
7. NOTE: Never hammer on the driveshaft, or any of its components, to disconnect the driveshaft flange from the differential pinion flange.
Using a suitable tool, pry only in the area shown to separate the driveshaft flange and the differential pinion flange.
8. Slide the driveshaft toward the rear of the vehicle, while maneuvering the front section over the top of the vehicle frame crossmember and remove
the driveshaft.
9. To install, reverse the removal procedure.
Driveshaft Slip Yoke Boot
Driveshaft Slip Yoke Boot
