Explorer 4WD V6-4.0L VIN E (1999)
Multifunction Electronic Control Module: Service and Repair
REMOVAL
1. Disconnect the battery ground cable.
CAUTION:
^
Prior to removal of module, it is necessary to upload module configuration information to New Generation STAR (NGS) Tester. This
information needs to be downloaded into the new module once installed.
^
Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.
2. Remove the radio chassis.
3. Remove the center instrument panel finish panel.
1
Remove the screws.
2
Remove the center instrument panel finish panel.
^
Disconnect the electrical connectors.
4. Remove the GEM/CTM.
1
Remove the screw.
2
Disconnect the four connectors from the GEM/CTM.
3
Remove the GEM/CTM.
INSTALLATION