Explorer 4WD V6-4.0L VIN E (1999)
Power Seat Control Module: Service and Repair
Heated Seat Module
REMOVAL
WARNING:
^
ALWAYS WEAR SAFETY GLASSES WHEN REPAIRING AN AIR BAG SUPPLEMENTAL RESTRAINT SYSTEM (SRS) VEHICLE
AND WHEN HANDLING AN AIR BAG MODULE. THIS WILL REDUCE THE RISK OF INJURY IN THE EVENT OF AN
ACCIDENTAL DEPLOYMENT.
^
AFTER DEPLOYMENT, THE AIR BAG SURFACE CAN CONTAIN DEPOSITS OF SODIUM HYDROXIDE, A PRODUCT OF THE
GAS GENERANT COMBUSTION THAT IS IRRITATING TO THE SKIN. WASH YOUR HANDS WITH SOAP AND WATER
AFTERWARD.
CAUTION: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.
1. Remove the power front seat track.
NOTE: Be sure to read and follow all air bag warnings.
2. Disconnect the heated seat module electrical connector.
3. Remove the heated seat module.
1. Release the clip.
2. Remove the heated seat module.
INSTALLATION
CAUTION: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.
