Explorer 4WD V6-4.0L VIN E (1999)
Parking Brake Control: Service and Repair
Removal
1. NOTE: Make sure the parking brake control is fully released.
Relieve the tension on the parking brake system.
1
Pull down on the parking brake intermediate cable.
2
Insert a 4 mm (5/32 inch) drill bit or equivalent retainer in the parking brake control.
2. Remove the LH front fender apron.
3. Remove the front parking brake cable and conduit from the retainer clip.
1
Remove the front parking brake cable and conduit retainer clip bolt.
2
Remove the front parking brake cable and conduit retainer clip.