Explorer 4WD V6-4.0L VIN E (1999)
14.
Cycle the key OFF then ON and hit TRIGGER.
15.
Turn the key OFF then hit TRIGGER.
16.
Next, turn the key ON being sure not to crank the engine. The NGS will now verify the current calibration. Hit TRIGGER to continue. The NGS
will then reprogram the PCM. This may take several minutes.
17.
The NGS will complete the reprogramming by running a KOEO Self Test.
18.
Disconnect the flash caRight-Hand Drive OBD-Ible.
19.
Proceed to Preparing Authorized Modification Label.
APPLICATION/CALIBRATION CHART
PREPARING AUTHORIZED MODIFICATION LABEL
1.
Obtain and prepare the Authorized Modification Label. Write the modification completed, your P&A code, the date of repair, the program type
