Explorer 4WD V6-4.0L VIN E (1999)
3. Install tile side air bag module onto the front seat back frame mounting bracket.
1. Position the side air bag module onto the front seat back mounting bracket.
2. In stall the middle, lower and upper side air bag module retaining nuts and tighten, in this sequence, to specification.
WARNING:
-
Inspect the mounting surfaces of the side air bag module and the seat back frame mounting bracket for any foreign objects before
installing the side air bag module. If any foreign objects are found, remove them. Failure to do so may result in personal injury, in the
event of an air bag deployment.
-
Inspect the side air bag deployment chute and the side air bag cavity in the seat back pad for any foreign objects. If any foreign
objects are found, remove them. Failure to do so may result in personal injury in the event of an air bag deployment.
-
Before installing the side air bag module, check it for damage and foreign objects. If the air bag module is damaged, replace it. If any
foreign objects are found, remove them. Failure to do so may result in personal injury, in the event of an air bag deployment.
-
If the air bag cover has separated or the air bag material has been exposed, install a new side air bag module. Do not attempt to repair
the air bag module. Failure to do so may result in personal injury in the event of an air bag deployment.
CAUTION: The retaining nuts of the side air bag module must be tightened in the sequence described.
