Explorer 4WD V6-4.0L VIN E (1999)
Crankshaft Position Sensor: Service and Repair
REMOVAL
1. Disconnect the battery ground cable.
2. Remove the Crankshaft Position (CKP) sensor.
1
Disconnect the CKP sensor electrical connector.
2
Remove the screws.
3
Remove the CKP sensor.
INSTALLATION
NOTE:
^
CKP sensor needs to be touching the damper. CKP sensor has wear tabs that wear off after several engine revolutions.
^
Be sure sensor wiring is routed away from the battery cable.
1. Install the CKP sensor.
1
Position the CKP sensor.
2
Install the screws.
3
Connect the CKP sensor electrical connector.
2. Connect the battery ground cable.
