Explorer 4WD V6-4.0L VIN E (1999)
readings by rotating the pinion with a Nm (inch-pound) torque wrench.
-
If installing new differential pinion bearings, tighten the nut to specification. Refer to Specifications.
-
If installing the original differential pinion bearings, the final reading must be 0.56 Nm (5 lb-in) more than the initial reading taken during
disassembly.
19. Install the special tool.
20. Install the differential case in the differential housing.
21. NOTE: Repeat this step until obtaining a consistent reading.
Measure the total end play.
1. Install the special tool.
2. Force the differential case as far as possible away from the indicator. Position the indicator tip on the machined surface and adjust it to
measure full travel. With force still applied, set the indicator to zero.
3. Force the differential case as far as possible in the opposite direction.
4. Record the total end play reading on the Differential Bearing Shim Selection Procedure Worksheet, Line A in this procedure.
