Explorer 4WD V6-4.0L VIN E (1999)
3. Install the driveshaft slip yoke.
1
Lubricate the stub shaft splines, and pull the driveshaft slip yoke boot towards the driveshaft.
-
Use Premium Long-Life Grease XG-1-C or -K or equivalent meeting Ford specification ESA-M1C75-B.
2
Fill the driveshaft slip yoke boot with approximately 10 grams of lubricant.
-
Use Premium Long-Life Grease XG-1-C or -K or equivalent meeting Ford specification ESA-M1C75-B.
3
Position the large driveshaft slip yoke boot clamp.
4
Align the index marks made during disassembly, and install the driveshaft slip yoke.
4. Install the large driveshaft slip yoke boot clamp.
1
Remove any excess grease from the differential slip yoke boot and driveshaft slip yoke surfaces.
2
Position the driveshaft slip yoke boot over the driveshaft slip yoke boot groove.
3
Position the driveshaft slip yoke to specification from the driveshaft weld to the end of the slip yoke splines.
4
Bleed air from the driveshaft slip yoke boot.
5
Use Keystone Clamp Pliers to crimp the large driveshaft slip yoke boot clamp.
5. Install the driveshaft.