Explorer 4WD V6-4.0L VIN E (1999)
UNTIL IT IS FULLY SEATED AND PARALLEL TO THE CV JOINT FACE. BE CAREFUL TO AVOID DAMAGING THE RUBBER
PORTION OF THE SEAL.
6.
Spread an approximately 3 mm (1/8") thick bead of High-Temperature Wheel Bearing Grease (E8TZ-19590-A) onto the new seal lips.
7.
Clean the inner surface of the knuckle (-3K185-/-3K186-). This is the metal surface the seals will ride against.
8.
Perform the halfshaft installation procedure per Section 205-04 of the appropriate Workshop Manual.
9.
Verity that the noise is no longer present.
Parts Block
OTHER APPLICABLE ARTICLES: NONE
SUPERSEDES: 01-4-11
WARRANTY STATUS: Eligible Under The Provision Of Bumper To Bumper Warranty Coverage.
OPERATION/DESCRIPTION/TIME
DEALER CODING
OASIS CODES: 509000, 597997, 702000, 702100, 703200, 703300