Explorer 4WD V6-4.0L VIN E (1999)
Wiper Switch: Service and Repair
Multifunction Switch
Removal
1. Disconnect the battery ground cable.
2. Remove the ignition switch lock cylinder.
1. Insert the ignition key into the ignition switch lock cylinder and turn to RUN position.
2. Push the ignition switch lock cylinder release tab with a punch while pulling out the ignition switch lock cylinder.
3. If equipped, twist the tilt wheel handle and shank counterclockwise and remove.
4. Remove the upper and lower steering column shrouds.
1. Remove the screws.
