Explorer 4WD V8-4.6L (2008)
-
The head restraint sleeves incorporate an alignment tab that must face forward when installed.
Squeeze together the tip of the head restraint sleeve and pull the sleeve out of the frame tube.
8. CAUTION: Use care when separating the seat back trim cover from the hook-and-loop strip, or the hook-and-loop strip can be torn
from the backrest foam pad.
Separate the hook-and-loop fasteners. Remove the seat backrest trim cover.
9. Remove the backrest foam pad.
10. Remove the 2 outboard lower latch bolts.
-
To install, tighten to 40 Nm (30 lb-ft).
11. Remove the 2 inboard lower latch bolts.
-
To install, tighten to 40 Nm (30 lb-ft).
12. CAUTION: Do not detach the latch cable from the seat latches. The latch assembly is synchronized; if disassembled, the latch assembly
may not operate correctly.
Remove the latch assembly.
-
Do not separate or disassemble the latch assembly components.
13. To assemble, reverse the disassembly procedure.
60 Percent, Bench
SEAT BACKREST - SECOND ROW, 60 PERCENT, BENCH
