Explorer 4WD V8-4.6L (2008)
Passenger Seat Cushion (Part 2)
Special Tool(s)
Special Tool(s)
Removal and Installation
WARNING: Front seat backrest trim covers installed on seats equipped with seat side air bags cannot be repaired. A new trim cover must be
installed. Cleaning is permissible. Failure to follow these instructions may result in the seat side air bag module deploying incorrectly and
increase the risk of serious personal injury or death in a crash.
NOTE:
-
The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
All seats
1. Remove the front seat.
2. Remove the front seat backrest.
3. Remove the head restraint.
1
Using an appropriate tool, push in the hole while lifting up and release the head restraint from the head restraint guide.
2
Push in on the head restraint guide release tab and remove the head restraint.
