Explorer 4WD V8-4.6L (2008)
Apply silicone gasket and sealant in 2 places as shown.
4. Position a new oil pan gasket and the oil pan and install the bolts finger-tight.
5. Tighten the bolt in 3 stages in the sequence shown.
^
Stage 1: Tighten to 2 Nm (18 lb-in).
^
Stage 2: Tighten to 20 Nm (15 lb-ft).
^
Stage 3: Tighten an additional 60 degrees.
6. If equipped with a block heater, attach the block heater wiring harness retainers to the LH oil pan bolts.
7. Position the oil drain splash shield and install the bolts.
^
Tighten to 12 Nm (9 lb-ft).
8. Connect the oil temperature sensor electrical connector.
9. Attach the battery cable bracket and install the nut.
^
Tighten to 10 Nm (89 lb-in).
10. Attach the PSP hose bracket and install the nut.