Explorer 4WD V8-4.6L (2008)
Using new intake manifold gaskets, position the intake manifold.
2. Connect the vacuum hose to the rear of the intake manifold.
3. Connect the brake booster hose to the rear of the intake manifold.
4. Install the intake manifold bolts and tighten the bolts in the sequence shown in 2 stages.
^
Stage 1: Tighten to 2 Nm (18 lb-in).
^
Stage 2: Tighten to 10 Nm (89 lb-in).
5. Connect the CMCV electrical connector.
6. Attach the wiring harness retainers to the intake manifold.
7. Install a new O-ring seal, position the heated PCV fitting and install the bolts.
8. Connect the PCV hose to the heated PCV fitting on the intake manifold.
9. Connect the TP sensor electrical connector.
10. Connect the EVAP hose to the intake manifold.
11. Connect the electronic TB electrical connector.
12. Install the fuel rail and injectors.
13. Install the air cleaner outlet pipe.
