Explorer 4WD V8-4.6L (2008)
8. Remove the front suction accumulator-to-compressor line.
9. To install, reverse the removal procedure.
-
Install new O-ring seals and a new gasket seal.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil.
10. Evacuate, leak test and charge the refrigerant system.
Suction Accumulator To Evaporator Line
SUCTION ACCUMULATOR TO EVAPORATOR LINE
Removal and Installation
All vehicles
1. Remove the suction accumulator.
2. Remove the A/C line bracket nut at the dash panel and remove the A/C line bracket.
-
To install, tighten to 6 Nm (53 lb-in).
3. Remove the ground strap bolt at the dash panel.
