Explorer 4WD V8-4.6L (2008)
5. Apply a maximum of 206.85 kPa (30 psi) to the open end of the vacuum/pressure hose from the special tool. Transmission fluid will immediately
start flowing out of the special tool into the transmission.
6. NOTE: Do not overfill the transmission. The transmission fluid level must be at the upper level of the crosshatch mark.
Reinstall the transmission fluid level indicator only back into the transmission fluid fill plug hole to check the transmission fluid level. Repeat this
until a consistent reading is established.
7. Using the scan tool verify that the transmission fluid temperature is between 80° C-85° C (175° F-185° F). The transmission fluid level must be at
the upper level of the crosshatch mark.
8. NOTE: If the transmission fluid is over full, follow the steps for Removing Transmission Fluid in this procedure.
Install the transmission fluid fill plug.
^
Tighten to 35 Nm (26 lb-ft).
