Explorer 4WD V8-4.6L (2008)
3. Remove the bolt and safety belt anchor.
-
To install, tighten to 40 Nm (30 lb-ft).
4. Detach the upper C-pillar trim panel and position aside.
5. Position aside the quarter trim panel.
-
Pull out on the quarter trim panel at the C-pillar to release the retaining clips and access the C-pillar side impact sensor.
6. Disconnect the electrical connector.
7. NOTE:
-
Note the position of the sensor and bracket locating tab for installation.
-
Make sure the C-pillar and side impact severity sensor mating surfaces are clean and free of foreign material.
Remove the 2 bolts and side impact sensor.
-
To install, tighten to 12 Nm (9 lb-ft).
8. WARNING: Always tighten the fasteners of the restraints control module (RCM) and impact sensor (if equipped) to the specified torque.
Failure to do so may result in incorrect restraint system operation, which increases the risk of personal injury or death in a crash.
NOTE: Make sure the safety belt webbing is not twisted prior to installation.
To install, reverse the removal procedure.
9. Repower the SRS.
