Explorer 4WD V8-4.6L (2008)
9. NOTE: Rotating the parking brake control counterclockwise allows enough access to clear the instrument panel reinforcement.
Remove the 3 bolts and position the parking brake control assembly under the brake pedal.
10. CAUTION: The lower side of the headlight switch bezel includes 2 tabs that slide down onto the instrument panel and may be broken if
any prying force is exerted in the lower area of the bezel.
Using a suitable tool, pry the mid-to-upper side of the headlight switch bezel away from the instrument panel (then lift it upward to disengage the
lower tangs from the instrument panel), disconnect the 2 electrical connectors and position the bezel assembly aside.
11
If necessary, push the LH instrument panel side finish panel out and position it aside.
12. Through the headlight switch bezel opening, remove the 2 SJB bolts.
13. From under the instrument panel, remove the third (lower right) SJB bolt.
14. NOTE: The SJB electrical connector levers must click into a fully released position before they can be removed and must click into a fully closed
(connected) position when installing.
Pull the SJB down out of the 2 locating pins, disconnect the 5 electrical connectors and remove the SJB.
Installation
NOTE: When a new SJB is installed, all customer RKE transmitters may be required to be present in order to program the RKE transmitters to the
new SJB.
1. NOTE: The SJB electrical connector levers must click into a fully released position before they can be removed and must click into a fully closed
(connected) position when installing.
Position the SJB into the 2 locating pins and connect the 5 electrical connectors.
2. From under the instrument panel, install the lower, right SJB bolt.
3. Through the headlight switch bezel opening, install the 2 SJB bolts.
4. If necessary, install the LH instrument panel side finish panel.
5. Connect the 2 electrical connectors and install the headlight switch bezel assembly into the instrument panel.
6. Position the parking brake control assembly and install the 3 bolts.
-
Tighten to 20 Nm (15 lb-ft).
7. Install the harness clip on the parking brake cable housing.
8. Install the hood release cable pushpin into the parking brake control bracket.
9. Connect the parking brake switch electrical connector.
10. Position the parking brake release handle and install the 2 bolts.
11. NOTE: While installing the trim panel, pull the hood release lever rearward in order for the release lever to slide through the trim panel.
Position the cowl side trim panel and install the pushpin.
12. Position the LH door opening weather seal.
13. NOTE: If the SJB was not replaced, this is the last step that is necessary.
Install the driver door scuff plate.
14. NOTE:
-
When successful, this step provides the calibration necessary for the SJB operation and clears DTC B2477. The clearing of this DTC indicates
the calibration data has been successfully downloaded to the new SJB.
-
When successful, this step also programs the remote transmitters into the new SJB. In the event the remote transmitters do not program to the
new SJB, all of the remote transmitters will need to be present and refer to Locks, Remote Keyless Entry Transmitter Programming. This
action will program the remote transmitters into the new SJB. See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Keyless
Entry/Keyless Entry Transmitter/Testing and Inspection/Remote Keyless Entry Transmitter Programming
Download the SJB configuration information from the scan tool into the new SJB.
15. NOTE: When successful, this step clears DTCs B2868, B2869, B2870 and B2871. The clearing of these DTCs indicates the SJB has recognized
the tire pressure sensors during the training procedure.
Train the tire pressure sensors.
