Explorer 4WD V8-4.6L (2008)
Removal
CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure may
result in major service expense. New parts must be installed with the same part numbers or equivalent part, if replacement is necessary. Do
not use a replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of
correct retention of these parts.
CAUTION: Orientation of the suspension fasteners is important. Make sure the fasteners are installed in the same direction as they were in
when removed or incorrect clamp load and damage to components may occur.
1. Measure the distance from the center of the hub to the lip of the fender with the vehicle in a level, static ground position (curb height).
2. If equipped, remove the wheel speed sensor bolt and position the sensor aside.
3. CAUTION: Do not loosen the halfshaft nut and washer until the wheel and tire are removed from the vehicle. Wheel bearing damage will
occur if the wheel bearing is unloaded with the weight of the vehicle applied.
NOTE: Apply the brake to keep the halfshaft from rotating.
Remove and discard the wheel hub nut.
4. Remove the parking brake shoes.
5. CAUTION: Do not use a hammer to separate the halfshaft from the hub. Damage to the threads and internal constant velocity (CV) joint
components may result.
