Explorer 4WD V8-4.6L (2008)
6. Remove the 4 nuts and remove the selector lever housing from the vehicle.
Installation
NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place and the selector lever cable
end is snapped onto the ball stud. Press the selector lever cable into the selector lever cable bracket and listen for the selector lever cable to click in
place. Pull back on the selector lever cable to make sure that it is locked into the selector lever cable bracket. Also make sure that the selector lever
cable end is correctly installed onto the ball stud. Pull back on the selector lever cable end to make sure that the selector lever cable end is correctly
installed.
1. Install the selector lever housing.
^
Tighten to 9 Nm (80 lb-inch).
2. Connect the wiring harness to the selector lever housing.
