Explorer 4WD V8-4.6L (2008)
12. Tighten the transmission fluid pan screws in a crisscross sequence.
^
Tighten to 11 Nm (8 lb-ft).
13. CAUTION: Damage will occur to the transmission control solenoid body assembly if the screw is tightened above specification.
NOTE: Always install new O-ring seals on the transmission control solenoid body harness connector.
NOTE: Clean the area around transmission control solenoid body harness connector to prevent contamination of the transmission control solenoid
body harness connector.
NOTE: Use petroleum jelly to lubricate the O-ring seals to aid in the installation process.
Install and lubricate new O-ring seals on the transmission control solenoid body harness connector and connect the transmission control solenoid
body harness connector.
^
Tighten to 5 Nm (44 lb-inch).
14. Fill the transmission.
6R60 - Automatic Transaxle/Transmission
Mechatronic Assembly
