Explorer 4WD V8-4.6L (2008)
3. Loosen the bolt inside the center cardan joint enough to allow the C-washer to fall from under the bolt head.
^
To install, tighten to 37 Nm (27 lb-ft).
4. NOTE: Index-mark the front and rear driveshaft sections.
NOTE: The rear section has a master splined shaft and yoke.
NOTE: The bolt head will fit through the internal spline of the center cardan.
Using a rubber mallet, separate the driveshaft sections.
5. Using a suitable puller, remove the driveshaft center bearing from the rear section.
