Explorer 4WD V8-4.6L (2008)
CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure may
result in major service expense. New parts must be installed with the same part numbers or equivalent part, if replacement is necessary. Do
not use a replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of
correct retention of these parts.
1. Remove the wheel and tire.
2. Remove and discard the halfshaft nut and washer.
^
To install, tighten to 250 Nm (184 lb-ft).
3. Using the special tool, separate the outboard constant velocity (CV) joint from the wheel hub.
4. CAUTION: Do not allow the caliper and anchor plate assembly to hang from the brake hose or damage to the hose can occur.
