Explorer 4WD V8-4.6L SOHC VIN W (2004)
Seat Sensor/Switch: Service and Repair
SEAT POSITION SENSOR
REMOVAL
WARNING:
-
Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module.
This will reduce the risk of injury in the event of an accidental deployment.
-
After deployment, the air bag surface can contain deposits of sodium hydroxide, a product of the gas generant combustion that is
irritating to the skin. Wash your hands with soap and water afterwards.
-
Never probe the connectors on the air bag module. Doing so can result in air bag deployment, which can result in personal injury.
-
To reduce the risk of serious personal injury, do not use any memory saver devices.
NOTE:
-
The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate
a supplemental restraint system (SRS) fault.
-
Restraint system diagnostic tools MUST be installed under the seats in the seat side air bag (if equipped) and safety belt pretensioner (if equipped)
to floor connectors.
-
After diagnosing or repairing an SRS, the restraint system diagnostic tools must be removed before operating the vehicle over the road.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
1. NOTE:
-
The seat position sensor is mounted at the LH rear of the seat track.
-
Position the driver seat forward enough so that upon removal the sensor can clear the magnetic bar and bracket.
Position the front seat to gain access to all four mounting bolts.
2. Depower the system.
3. Remove the driver seat.
