Explorer 4WD V8-4.6L SOHC VIN W (2004)
To remove individual parts, only carry out the listed steps above:
4. To install, reverse the removal procedure.
5. Check and, if necessary, align the rear end.
Item 1: Axle Nut Removal Note
1. CAUTION: Do not use a hammer to separate the outboard CV joint from the hub. Damage to the threads and internal CV joint components can
result.
Using the special tool, press the outboard CV joint until it is loose from the hub.
Item 3: Toe Link-to-Wheel Knuckle Bolt Removal Note
1. CAUTION: Do not damage the boot while separating the toe link from the wheel knuckle.
Remove the bolt and separate the toe link from the wheel knuckle.
Item 5: Upper Arm-to-Wheel Knuckle Bolt Removal Note
1. CAUTION: Do not damage the boot while separating the ball joint from the wheel knuckle.
Remove the bolt and separate the upper arm from the wheel knuckle.
Item 10: Wheel Hub Removal Note