Explorer 4WD V8-4.6L VIN W (2002)
NOTE: Never reuse brake fluid that has been drained from the hydraulic system or has been allowed to stand in an open container for an
extended period of time.
Lubricate the piston boot, caliper piston, piston seal, and cylinder bores with High Performance DOT 3 Motor Vehicle Brake Fluid
C6AZ-19542-AB or DOT 3 equivalent meeting Ford specification ESA-M6C25-A.
2. Install the caliper pistons.
1. Install the piston seal.
2. Install the piston boot onto the piston.
3. CAUTION: Be careful not to damage or dislodge the piston seal.
Insert the caliper piston.
4. Press the caliper piston into the caliper bore, being careful not to cock the caliper piston and press the piston boot into the housing counter
bore.
3. Install the disc brake caliper.
Brake Caliper Support Bracket
Brake Caliper Support Bracket
Removal
1. Remove the pads.
2. Remove the front disc brake caliper support bracket.
1. Remove and discard the two front disc brake caliper support bracket bolts.
2. Remove the front disc brake caliper support bracket.
Installation
