Explorer 4WD V8-4.6L VIN W (2002)
Parking Brake Cable: Service and Repair
Cable and Conduit - Front
Cable and Conduit - Front
Removal and Installation
1. Remove the parking brake control.
2. Remove the parking brake anchor pin from the parking brake control.
3. Bend the takeup spool tab up.
4. Remove the front parking brake cable and conduit housing.
1. Compress the front parking brake cable and conduit-to-parking brake control clip.
2. Remove the front parking brake cable and conduit housing.
5. To install, reverse the removal procedure.
^
Make sure cable is routed through loop on takeup spool.
