Explorer 4WD V8-4.6L VIN W (2002)
Aft
REMOVAL
CAUTION: The refrigerant lines contain high pressure refrigerant. Lay out the new aft auxiliary heater inlet and/or outlet line(s) to assist in installation,
and avoid confusion between auxiliary heater and auxiliary refrigerant lines.
NOTE: The following procedure can be used to remove and install one of, or both, the aft auxiliary heater outlet and inlet lines. If only one line is to be
removed and installed, disconnect only the desired hose connections at the specified points within the procedure.
1. Drain the engine coolant.
2. Raise the vehicle.
3. Remove the spare tire carrier.
4. Compress the clamp(s) and disconnect the heater hose.
NOTE: If only one heater line is to be replaced, disconnect only the clamp for the desired line.
5. Compress the clamp(s) and disconnect the heater hose.
NOTE: If only one heater line is to be replaced, disconnect only the clamp for the desired line.
6. Remove the nut and remove the bracket.
