Explorer 4WD V8-4.6L VIN W (2002)
Speed Sensor: Service and Repair
Transfer Case-Automatic Shift - Rear
Output Shaft Speed (OSS) Sensor - Rear
Removal and Installation
1. With the vehicle in the NEUTRAL position, raise and support vehicle.
2. Remove the heat shield.
3. Disconnect the electrical connector.
4. Remove the rear output shaft speed sensor wires from the electrical shift motor connector.
1
Remove the connector interlock.
2
Remove the wires.
Use the proper electrical connector pin remover.
5. Remove the bolt and the sensor.
