Explorer 4WD V8-4.6L VIN W (2002)
4. Remove the driver air bag module.
1. Slide and disengage the driver air bag module electrical connector locking clip.
2. Push in on the two release tabs and disconnect the driver air bag module electrical connector.
3. Disconnect the horn switch electrical connector.
4. Remove the driver air bag module.
Vehicles built 03/2002 onward
5. Remove the driver air bag module.
1. Release the two retaining tabs. Disconnect the driver air bag module electrical connector.
-
Label the driver air bag module squib number on the driver air bag module electrical connector before disconnecting.
2. Release the two retaining tabs. Disconnect the driver air bag module electrical connector.
-
Label the driver air bag module squib number on the driver air bag module electrical connector before disconnecting.
3. Disconnect the horn switch electrical connector.
4. Remove the driver air bag module.
Installation
Vehicles built 03/2002 onward
1. Position the driver air bag module to the steering wheel.
1. Connect the horn switch electrical connector.
2. CAUTION: The clockspring electrical connectors are unique and cannot be reversed when connected to the driver air bag module.
Match the electrical connector key to the keyway in the driver air bag module. Do not force the electrical connectors into the driver
air bag module.
Connect the driver air bag module electrical connectors as noted during removal.
3. Position the driver air bag module to the steering wheel.
Vehicles built up to 03/2002
