Explorer 4WD V8-4.6L VIN W (2002)
2. Check the active restraint system for correct operation.
Safety Belt - Second Row, 60/40, Center
Safety Belt Bolt Bit
SPECIAL TOOL(S)
REMOVAL
WARNING: ALL SAFETY BELT ASSEMBLIES INCLUDING RETRACTORS, BUCKLES, FRONT SEAT BELT BUCKLE SUPPORT
ASSEMBLIES (SLIDE BAR), SHOULDER BELT HEIGHT ADJUSTERS (IF SO EQUIPPED) CHILD SAFETY SEAT TETHER
ATTACHMENTS AND ATTACHING HARDWARE SHOULD BE INSPECTED AFTER ANY COLLISION. ALL BELT ASSEMBLIES
SHOULD BE REPLACED UNLESS A QUALIFIED TECHNICIAN FINDS THE ASSEMBLIES SHOW NO DAMAGE AND OPERATE
PROPERLY. BELT ASSEMBLIES NOT IN USE DURING A COLLISION SHOULD ALSO BE INSPECTED AND REPLACED IF EITHER
DAMAGE OR IMPROPER OPERATION IS NOTED.
1. Tilt the second row 60 percent portion of the 60/40 seat forward.
2. Remove the safety belt and buckle assembly.
1
Remove the bolts.
2
Remove the safety belt and buckle assembly.
INSTALLATION
1. To install, reverse the removal procedure.
^
After installation, position the second row seat back and check for safety belt and buckle accessibility.
2. Check the active restraints for correct operation.