Explorer 4WD V8-4.6L VIN W (2002)
4. Tighten the nut.
5. Check and if necessary adjust the rear toe.
Camber and Caster Adjustment-Front
Camber and Caster Adjustment-Front
1. NOTE: The upper arm-to-frame mounting bolts have set shims that must be replaced with washers to allow for adjustment of the arm in the frame
slot. The vehicle should be supported by the lower arm to ease movement of the upper arm in the slot.
Remove the nuts and the shims.
^
Discard the nuts and shims.
^
Install new washers and nuts and snug the nuts.
2. To adjust the caster and camber refer to the chart.
^
Adjustments that require moving the front and the rear of the upper arm should be made equally.